Dissolved Oxygen Product Category - Sensorex Liquid Analysis Technology

The Lumin-S optical dissolved oxygen sensor delivers reliable DO measurements over a long operating life. There are no membranes to replace, no electrolyte solutions to replenish, and no anodes to clean. Maintaining the sensor is as easy as replacing the optical sensing cap once every 1-2 years, and since all calibration data is stored on the cap, there’s no need to calibrate. This dissolved oxygen sensor outputs a Modbus/RS-485 digital signal for easy PLC integration. Available with Stainless Steel or Titanium body Reliable measurements: Optical sensor technology delivers accurate DO monitoring with no drift and no minimum flow Long operating life with minimal maintenance:  No membranes, electrolyte solutions, or anodes – just replace the cap once every 1-2 years No calibration: All

Now Available with optional MODBUS/RS485 Interface Our DO6400 series of galvanic dissolved oxygen sensors deliver accurate measurements with very fast response time. Calibration is simple and only requires a single-point air calibration. Sensor directly outputs Millivolt, 4-20mA analog or MODBUS/RS485 digital signal scaled to the sensor range for easy PLC integration. Fast response time for accurate dissolved oxygen monitoring Direct MilliVolt, 4-20mA analog or MODBUS/RS485 digital output signal to integrate with a PLC or other control system Input Voltage Options: 12V DC – MODBUS only 24V DC – 4-20mA & MODBUS Ready for long-term deployment with large electrolyte reservoir One year limited warranty

Quickly and easily configure, calibrate and test your Sensorex smart sensor.

Replacement cap for Sensorex Lumion-S OPtical Dissolved Oxygen Sensors

Our DO1200 galvanic dissolved oxygen sensors measure the oxygen content of water using an electrochemical measurement principle. Built in an economical but durable 12mm epoxy body, these sensors are suitable for portable or benchtop use. The DO1200 can also be installed inline for continuous monitoring applications by upgrading to a PTFE membrane cap. The sensor is compatible with our FC75P 3/4 inch in-line fitting for mounting into 3/4 inch FNPT threaded tees. Galvanic (electrochemical) measurement principle Replaceable membrane cap and fill solution 12mm durable epoxy body For benchtop, portable, or inline use hbspt.cta.load(3822158, '4e4823a4-30d0-4be8-a97e-17e6240dd091', {});

The LPM100 is a durable, loop-powered 4-20mA display for use in process monitoring applications. Monitor various parameters, including UV transmittance, free chlorine, dissolved oxygen, and more. This large display meter can be mounted in various configurations – including pipe mounting with our pipe mount kit . Simple installation and operation make it an ideal solution for process read out monitoring. Compatible with Sensorex 4-20mA output sensors Durable for harsh environmental conditions Simple set up and operation User-friendly interface One year limited warranty